25 Micro Bangs, a Short Clean Line

Micro bangs sit about an inch above the brow, which means a three-week trim schedule and almost no room to hide a crooked line. I cut every short fringe dry, shears flat, since wet hair dries shorter and curls can spring up two inches. Fine, straight hair holds that line most easily.

1. Blunt Micro Fringe on a Jaw-Length Bob

micro bangs

Heart and oval faces with 1A to 1C texture and fine to medium density hold the two hard lines of blunt micro bangs on a jaw-length bob, one across mid-forehead and one at the jaw. Shears flat, I cut the bob dry, then cut the fringe straight an inch above the brow without any point cutting. Style flat with a paddle brush and a serum finish. Trim the bangs every three weeks.

2. Inch-and-a-Half Mini Bangs on Long Straight Hair

micro bangs

Oblong and oval faces with 1A to 1C texture and fine to medium density suit mini bangs on long straight hair, set an inch and a half above the brow and sharpest when the lengths are sleek. Working dry, I cut a narrow section between the arches, then take the corners off with light point cutting. Style the fringe down with a flat brush and flat iron the rest. Trim every three weeks.

3. Curl-by-Curl Micro Bangs

micro bangs

Heart and oval faces with 3A to 3C texture and medium to thick density can wear micro bangs on curls if I cut each curl dry, two inches past the goal, since the spring is that strong. I choose single curls from a narrow section, cut at the brow, and let them shrink up to mid-forehead. Style with curl cream and diffuse the fringe forward. Trim every four weeks.

4. See-Through Wispy Micro Bangs

micro bangs

Heart and oval faces with 1A to 2A texture and fine to medium density suit wispy micro bangs, thinned until the forehead shows between strands. On dry hair I take a shallow section an inch above the brow and point cut deep until single pieces break off. Style down with a flat brush and no product, so the strands stay separate. Trim every three weeks.

5. Tapered Pixie With Mini Bangs

micro bangs

Heart and oval faces with 1A to 2A texture and fine to medium density suit mini bangs on a pixie: a short fringe at mid-forehead against tapered sides. Working dry, I taper the sides and nape, leave three inches up top, then cut the fringe an inch above the brow and point cut the ends. Style the fringe down and the top forward with a little paste. Trim the bangs every three weeks.

6. Full-Width Micro Bangs for Oval Faces

micro bangs

Oval faces with 1A to 2A texture and fine to thick density can take micro bangs at any width, so I use the full width of the brow and keep the line straight. On dry hair I cut an inch above the brow and only soften the corners. Style down with a flat brush, then a light spray to hold. Trim every three weeks.

7. Broken-Edge Choppy Micro Bangs

micro bangs

Square and oval faces with 1A to 2B texture and medium to thick density suit choppy micro bangs, point cut an inch deep so the short line looks broken instead of ruler straight. Working dry, I cut at mid-forehead and point cut into the ends until the edge breaks up. Style by rough-drying forward and piecing with paste. Trim every three weeks.

Save this article

Enter your email and we'll send it straight to your inbox.

No spam. Unsubscribe anytime.

8. Jaw-Length French Bob With Mini Bangs

micro bangs

Heart and oval faces with 1A to 2A texture and fine to medium density suit the French bob with mini bangs, which keeps the perimeter at the jaw and the fringe short enough to show forehead. Shears flat, I cut the bob dry, then cut the fringe an inch above the brow and point cut lightly. Style under with a round brush and bend the front with a flat iron. Trim every four weeks.

9. Steep Face-Framing Layers With Micro Bangs

micro bangs

Square and round faces with 1A to 2B texture and medium density suit micro bangs with face framing layers, which connect along a steep angle from mid-forehead to the cheekbone. Working dry, I cut the fringe an inch above the brow, then point cut the frame from the temple so it drops quickly. Style the fringe down and the layers away from the face. Trim every five weeks.

10. Blunt Mini Bangs for Fine Hair

micro bangs

Round and oval faces with fine density and 1A to 2A texture suit micro bangs when the section stays shallow and the ends stay blunt, so the short fringe looks full. I cut dry, an inch above the brow, shears flat, with no thinning at all. Style down with a flat brush and a mist of light spray. Trim every three weeks.

11. Razored Shag With Micro Bangs

micro bangs

Square and oval faces with 1B to 2B texture and medium to thick density suit a shag with micro bangs, which pairs razored crown layers with a short fringe above the shortest layer. On dry hair I razor the crown, point cut the ends, cut the fringe at mid-forehead and razor its edge. Style with sea salt spray, rough-dried and shaken out. Trim every five weeks.

12. Softened Mini Bangs for Women Over 40

micro bangs

Heart and oval faces over 40 with fine to medium density and 1A to 2A texture suit mini bangs with a point-cut edge, sitting an inch and a half above the brow rather than two. I cut dry and point cut along the whole edge. Style down with a flat brush and volumizing mousse at the root. Trim every four weeks.

13. Shallow-Section Micro Bangs for Thick Hair

micro bangs

Any face shape with thick density and 1A to 2B texture can wear micro bangs if they come from a half-inch section; deeper, the short fringe sticks straight out. Working dry, I cut an inch above the brow, point cut and remove interior weight so the bangs lie flat. Style down with a flat brush and smoothing cream. Trim every three weeks.

14. Short Fringe With Platinum Color

micro bangs

Cool skin tones with fine to medium density suit platinum with micro bangs, with the fringe cut only after toning, since the lift changes how the short edge lies. I bring the hair to level ten and tone violet, then cut the fringe an inch above the brow on dry hair, shears flat. Style the fringe down and use a bond builder weekly. Retouch every four weeks.

15. Collarbone Lob With Micro Bangs

micro bangs

Heart and oval faces with 1A to 1C texture and fine to medium density suit a sleek lob with micro bangs: a short fringe over a collarbone-length perimeter with no layers. Shears flat, I cut the perimeter dry, then cut the fringe an inch above the brow. Style flat with a paddle brush, flat iron the lengths and keep the bangs soft. Trim every five weeks.

16. Brow-Tracing Curved Mini Bangs

micro bangs

Square and round faces with 1A to 2A texture and fine to medium density suit curved mini bangs, shorter in the center and longer at the temples so the edge follows the brow line. On dry hair I cut the center an inch above the brow, angle each side to the arch and point cut the ends. Style down with a flat brush. Trim every three weeks.

17. Short Center Fringe With Curtain Pieces

micro bangs

Heart and oval faces with 1A to 2B texture and fine to medium density suit micro bangs with curtain pieces, which keep the middle short while two longer pieces fall to the cheekbone. Working dry, I cut the center an inch above the brow, leave a half-inch section long on each side and angle it to the cheekbone. Style the center down and the side pieces out. Trim every four weeks.

18. Short Fringe on Dark Brunette Hair

micro bangs

Cool or neutral skin tones with fine to thick density suit dark brunette with micro bangs, the shade that shows the short line most clearly against skin. Shears flat, I cut the fringe an inch above the brow on dry hair, then apply a level four demi root to end. Style the fringe down with a serum finish. Refresh the tone every eight weeks.

19. Brow-Length Cut for Wavy Micro Bangs

micro bangs

Square and oval faces with 1C to 2B texture and medium density suit micro bangs on wavy hair, cut at the brow so they spring up to mid-forehead once the bend sets. I cut dry, point cut the ends, and recheck length after the waves dry. Style by scrunching light cream into the fringe and air-drying it with the rest. Trim every four weeks.

20. Forehead-Wide Micro Bangs for Heart Faces

micro bangs

Heart faces with 1A to 2A texture and fine to medium density balance out with micro bangs that run the full width of the forehead, so the wide top offsets the narrow chin. Working dry, I cut the full width an inch above the brow and point cut the corners. Style down using a flat brush and finish with a light spray. Trim every three weeks.

21. Graduated Pixie Bob With Mini Bangs

micro bangs

Heart and oval faces with 1A to 2A texture and fine to medium density suit a pixie bob with mini bangs: a short stacked nape, a front at the earlobe and a fringe at mid-forehead. On dry hair I taper the nape, graduate to the occipital, angle the front to the earlobe and cut the fringe an inch above the brow. Style the fringe down and the front under. Trim every four weeks.

22. Short Fringe With Copper Color

micro bangs

Warm skin tones with fine to medium density suit copper with micro bangs, which brings the brightest color to the top of the forehead. Working dry, I cut the fringe an inch above the brow, then use a level seven copper at the root and a demi on the ends. Style the fringe down with shine serum. Refresh the tone every five weeks and trim the bangs every three.

23. Hard-Line Shoulder Cut With Micro Bangs

micro bangs

Oblong and oval faces with 1A to 1C texture and fine to medium density suit a blunt shoulder cut with micro bangs: one hard line at the shoulder, a short one at the forehead. Shears flat, I cut the perimeter at the shoulder on dry hair, then cut the fringe an inch above the brow. Style flat with a paddle brush, ends bent under. Trim every six weeks.

24. No-Brush Micro Bangs

micro bangs

Any face shape with 1C to 2B texture and fine to medium density suits micro bangs that air-dry, point cut deep so the short pieces fall into place without a brush. Working dry, I cut an inch above the brow and point cut until the edge breaks apart. Style by smoothing a light cream into damp bangs, pressing them down and leaving them. Trim every four weeks.

25. Stacked Inverted Bob With Micro Bangs

micro bangs

Heart and oval faces with 1A to 2A texture and fine to medium density suit an inverted bob with micro bangs: a short stacked back, a chin-length front and a fringe at mid-forehead. On dry hair I graduate the nape, angle the front to the chin and cut the fringe an inch above the brow. Style the fringe down and the front under. Trim every four weeks.

See also french bangs and short hair with bangs.

Micro bangs read sharpest as a short, even line above the brow, because that brevity is what makes the cut look intentional. A small flat iron keeps the edge straight.

Save this article

Enter your email and we'll send it straight to your inbox.

No spam. Unsubscribe anytime.

Scroll to Top