A soft shag haircut on fine to medium hair in the 1A to 2B range holds its shape into second-day hair, because the layers are point cut long and blended instead of stacked. Most of these are cut dry at the collarbone or shoulder, finished with a round brush or a light cream, and trimmed every six to eight weeks.
1. The Long-Layered Soft Shag Haircut

Fine to medium density and 1A to 2B texture on most face shapes wear this soft shag haircut, the one I do most often, with layers kept long and blended so the shape moves without steps. Working on dry hair, I take the perimeter past the collarbone, point cut from the cheekbone with the shears close to upright, and texturize the crown a little. Style with a round brush, leaving the ends loose. Trim every eight weeks.
2. Soft Shag Haircut Mid Length, Collarbone Cut
Best on fine to medium density and 1A to 2B texture, this soft shag haircut mid length falls to the collarbone, layers starting at the chin and no hard crown line. I set the perimeter dry at the collarbone and point cut the layers from the chin. The crown is point cut to five inches, enough to lift while it blends. Rough-dry using a light cream and bend the ends with a flat iron. Trim every eight weeks.
3. Soft Shag Cut With Curtain Bangs
Round and square faces with fine to medium density and 1B to 2B texture suit curtain bangs on a soft shag, left long and point cut to blend into the face frame. I take the perimeter dry to the collarbone and point cut layers from the chin. Then I section a triangle and cut the bangs between the cheekbone and the jaw. Style the bangs out with a small round brush. Trim every six weeks.
4. The Fine-Hair Soft Shag
Fine density, 1A to 2A texture, and an oval or oblong face are where this soft shag works: solid perimeter, few layers, full ends. Holding the shears flat, I cut a collarbone perimeter dry. Two long layers are point cut from the chin, and only the crown is texturized. Style by putting mousse on damp roots and lifting the crown with a round brush. Trim every six weeks.
5. Soft Shag Cut With Wispy Bangs
Oval and oblong faces in fine to medium density and 1A to 2A texture wear wispy bangs on a soft shag, point cut thin to sit between the brows. I cut the perimeter dry at the collarbone and point cut the layers from the chin. The bangs are cut at the brow, then point cut until the pieces separate. Style the bangs down with a small brush; let the rest air-dry. Trim the bangs every four weeks.
6. Side-Parted Soft Shag Haircut Mid Length
Round and square faces with fine to thick density and 1A to 2B texture suit a side part on this soft shag haircut mid length, where the layers fall in one sweep. I cut the perimeter dry at the shoulder and point cut layers from the chin. The part goes two inches off center. Style with a round brush, pushing the heavy side back. Trim every eight weeks.
7. The Thick-Hair Soft Shag
Thick density and 1B to 2C texture on any face shape call for point cut internal layers on a soft shag, not a razor, so bulk comes out and ends stay clean. Working dry, I take the perimeter past the collarbone and point cut internal layers through the sides. The crown is point cut to five inches. Style by rough-drying with a light cream and leaving the ends alone. Trim every eight weeks.
Save this article
No spam. Unsubscribe anytime.
8. Over-50 Soft Shag Haircut
Fine to medium density and 1A to 2A texture over 50 suit this version, with crown layers held at five inches, ends point cut to stay thick, and a side swept fringe to the cheekbone. I set the perimeter dry at the shoulder. The layers and fringe are point cut, and the shape is texturized lightly. Style with a round brush and a smoothing cream. Trim every eight weeks.
9. Soft Wavy Shag for 2A to 2C Hair
Any face shape in fine to medium density with 2A to 2C hair can wear a soft wavy shag, where each wave gets its own layer and doesn’t split apart. I cut the perimeter dry at the collarbone and point cut layers from the chin. Then the crown is point cut to five inches. Style by scrunching mousse into damp hair, parting to one side, and air-drying with the crown clipped up. Trim every eight weeks.
10. Soft Shag Haircut Mid Length, Face-Framing Layers
Fine to thick density and 1A to 2B texture suit this soft shag haircut mid length with face framing layers, the frame kept long from the cheekbone and curving to the collarbone. I take the perimeter dry to the shoulder and point cut the face frame from the cheekbone. The crown gets point cut to five inches. Style the face frame away from the face with a round brush. Trim every eight weeks.
11. Soft Shag Cut With Bottleneck Bangs
Oval and oblong faces in fine to medium density and 1B to 2B texture suit bottleneck bangs on a soft shag, brow length in the center and blended into the face frame at the cheekbone. I cut a dry collarbone perimeter and point cut layers from the chin. A triangle is sectioned and the bangs are cut. Style them with a small round brush. Trim every four weeks.
12. Long Soft Shag Past the Shoulder
Round, square, and oval faces with medium to thick density and 1A to 2C texture wear a long soft shag, length kept past the shoulder, layers from the chin, crown at six inches. Working dry, I take the perimeter past the shoulder and point cut layers from the chin. Then I point cut the crown. Style by rough-drying with a light cream and adding texture spray at the crown. Trim every ten weeks.
13. Soft Shag Haircut Cut for Straight Hair
Any face shape in fine to medium density and 1A to 1C texture can wear a soft shag haircut on straight hair, as long as each layer is point cut so the ends don’t stack in rows. I set the perimeter dry at the collarbone and point cut layers from the chin. The face frame is point cut deep from the cheekbone. Style with a round brush, then bend the ends out with a flat iron. Trim every eight weeks.
14. Soft Shag Cut With Side-Swept Fringe
Round and square faces with fine to medium density and 1A to 2B texture suit a side swept fringe on a soft shag, cut from the part to the cheekbone and blended into the face frame. I take a dry collarbone perimeter and point cut layers from the chin. The fringe runs from the part down to the cheekbone. Style it across with a flat brush. Trim the fringe every five weeks.
15. Balayage-Painted Soft Shag
Fine to thick density and 1B to 2B texture suit balayage on a soft shag, painted over the final three inches of every layer so the light lands on the ends. I cut the perimeter dry at the collarbone and point cut layers from the chin. Then I hand paint each layer’s ends up to a level nine. Style with a round brush and a serum finish. Refresh every twelve weeks.
16. Over-40 Soft Shag Haircut Mid Length
Fine to medium density and 1A to 2B texture over 40 suit a mid length soft shag with soft layers, a five-inch crown, and a face frame from the cheekbone. Working dry, I set the perimeter at the shoulder and point cut layers from the chin. The face frame is point cut next. Style with a round brush, smoothing cream worked through the ends. Trim every eight weeks.
17. Jaw-Length Short Soft Shag
Oval and heart faces in fine to medium density and 1B to 2B texture wear a short soft shag at the jaw, crown at four inches and sides point cut, not razored flat. I cut the perimeter dry at the jaw and point cut the crown to four inches. The sides are point cut so they fall soft. Style by rough-drying with a light paste and pushing the crown around. Trim every six weeks.
18. Soft Shag Cut With a Money Piece
Fine to medium density and 1A to 2B texture suit a money piece on a soft shag, which brightens the face frame and leaves the layers dark. I take a dry collarbone perimeter and point cut layers from the chin. The two front sections are lifted to a level nine and toned beige. Style the front pieces away from the face with a round brush. Refresh every ten weeks.
19. The Round-Face Soft Shag
Round faces in fine to thick density and 1A to 2B texture suit a soft shag with the face frame starting under the chin and the crown kept lifted. Working dry, I set the perimeter at the collarbone and point cut the face frame from below the chin. The crown is point cut to four inches. Style the crown up with a round brush and the face frame off the cheek. Trim every eight weeks.
20. Over-60 Soft Shag Haircut
Fine to medium density and 1A to 2A texture suit this soft shag haircut over 60: perimeter at the shoulder, layers at five inches, fringe side swept to the cheekbone. Everything is point cut on dry hair. A light texturizing pass finishes the ends. Style the crown up with mousse and a round brush. Trim every eight weeks, and plan a gloss every eight too.
21. Soft Shag Colored Copper
Warm skin tones with fine to medium density suit copper on a soft shag, which shows the layers in the light with no visible step. I cut a dry collarbone perimeter and point cut layers from the chin. A level seven copper goes on root to end. Style with a round brush and finish with serum. Refresh the tone every five weeks.
22. Curtain-Fringe Soft Shag With a Center Part
Oval and heart faces with fine to medium density and 1B to 2B texture suit a center part and curtain fringe on a soft shag, which frames the face evenly. I take the perimeter dry to the collarbone and point cut layers from the chin. Then I section a triangle and cut the fringe from brow to cheekbone. Style the fringe out with a small round brush. Trim the fringe every five weeks.
23. Air-Dry Soft Shag Haircut Mid Length
Fine to medium density and 1C to 2B texture suit this soft shag haircut mid length built to air-dry, crown at five inches and face frame from the chin. Working dry, I cut the perimeter at the shoulder and point cut the crown and face frame. The ends get texturized. Style by applying a light cream to damp hair, parting to one side, and leaving it until dry. Trim every eight weeks.
24. Soft Shag Cut With a Shadow Root
Fine to medium density and 1A to 2B texture suit a shadow root on a blonde soft shag, keeping depth at the crown and light at the ends. I cut a dry collarbone perimeter and point cut layers from the chin. A level six demi goes on the root, and the lengths stay at level nine. Style with a round brush. Refresh the root every ten weeks.
25. The Square-Face Soft Shag
Square faces in fine to thick density and 1A to 2B texture suit a soft shag whose face frame curves away before the jaw, softening the corners. Working dry, I set the perimeter at the collarbone and point cut the face frame from the cheekbone. The crown is point cut to five inches. Style the face frame off the face with a round brush. Trim every eight weeks.
For a fuller picture, see fairy shag haircut and wavy shag haircut.
A soft shag haircut reads easiest with gentle layers and a rounded face frame, because the shape comes from movement not chop. A wide-tooth comb through wet hair is most of the styling.
























