Hair for Oblong Face Shape: Stop the Length

Fine to medium hair on an oblong face tends to go flat at the sides by mid-afternoon, right where that face needs width. The best hair for an oblong face shape keeps the crown low, builds fullness at the cheekbone and jaw, and usually drops some fringe over the forehead to shorten the line.

1. Chin Bob Cut With a Blunt Fringe

hair for oblong face shape

Fine to medium density and 1A to 1C texture take this best: a chin length bob with a blunt fringe, the hair for oblong face shape I suggest before anything else. The fringe shortens the forehead while the bob widens the jaw. I cut the chin perimeter dry with flat shears and set the fringe at the brow. Paddle-brush it flat, fringe down. Trim every five weeks.

2. Waves Cut to the Shoulder

hair for oblong face shape

For fine to medium density and 1B to 2B texture, shoulder length waves build width at the cheekbone and jaw, the two places an oblong face needs it. I cut the shoulder perimeter dry, point cutting the ends, with one long layer at the chin. A one-inch iron waved away from the face, then a light spray to break it up, finishes it. Trim every eight weeks.

3. Curtain-Bang Lob at the Collarbone

hair for oblong face shape

Fine to medium density and 1B to 2B texture suit curtain bangs, which shorten an oblong face by covering some forehead and opening wide at the cheekbone. The perimeter goes to the collarbone, cut dry with point cut ends; then I section a triangle and take the bangs from brow to cheekbone. A small round brush blows them out. Trim the bangs every five weeks.

4. Side-Volume Short Cut for Oblong Faces: Short Hair for Oblong Face Shape

hair for oblong face shape

Fine to medium density and 1B to 2B texture do well with short hair for oblong face shape cuts, as long as the volume stays at the sides rather than on the crown. The jaw bob is cut dry with point cut ends, internal layers point cut through the sides, crown left flat. Round-brush the sides out; keep the top smooth. Trim every six weeks.

5. Wispy-Fringe Shoulder Cut With Layers

hair for oblong face shape

On an oblong face with fine to medium density and 1A to 2A texture, a wispy fringe removes an inch of visible forehead and skips the heaviness of a blunt one. The fringe is cut dry at the brow and point cut deeply; the length sits at the shoulder, layered from the chin. Small brush on the fringe, round brush on the rest. Trim the fringe every four weeks.

6. Side-Parted Bob to the Jaw

hair for oblong face shape

Fine to medium density and 1A to 2A texture work here, where a side part on a jaw length bob interrupts the vertical line through the center of an oblong face. The jaw perimeter is cut dry with point cut ends, parted on the heavier side, with one point cut layer at the cheekbone. Roll the heavy side under with a round brush. Trim every six weeks.

7. Over-50 Hair for Oblong Face Shape: Chin Bob With Swept Fringe

hair for oblong face shape

Fine to medium density and 1A to 2A texture suit the hair for oblong face shape over 50 that fills my book: a chin length bob, soft layers, side swept fringe. The chin perimeter is cut dry with point cut ends, layers point cut from the cheekbone, fringe from part to cheekbone. A round brush and smoothing cream finish it. Trim every six weeks.

Save this article

Enter your email and we'll send it straight to your inbox.

No spam. Unsubscribe anytime.

8. Textured Shaggy Lob

hair for oblong face shape

Medium to thick density with 1B to 2C texture suits a shaggy lob, which loads texture at the cheekbone and jaw so an oblong face reads wider. The collarbone perimeter is cut dry, layers point cut from the cheekbone, face frame razored, crown left long. Scrunch the ends after a rough-dry with texture spray. Trim every eight weeks.

9. Blunt Bob Cut at Chin Level

hair for oblong face shape

Fine to thick density and 1A to 1C texture handle a blunt bob at the chin, which sets a horizontal line along the bottom of an oblong face. The chin perimeter is cut dry with flat shears, and only the final half inch gets texturized. Paddle-brush it flat, part it to one side, and add serum. Trim every six weeks.

10. Chin-Bob Short Hair for Oblong Face Shape With Curtain Bangs

hair for oblong face shape

For fine to medium density with 1B to 2B texture, this short hair for oblong face shape option holds the bob at the chin with curtain bangs dropping to the cheekbone. The chin perimeter is cut dry with point cut ends; I section a triangle and cut the bangs brow to cheekbone. A small round brush blows the bangs out. Trim the bangs every five weeks.

11. Full-Fringe Long Layered Cut

hair for oblong face shape

Medium to thick density with 1A to 1C texture carries a full fringe on long hair, which cuts the forehead in two and stops the length from making an oblong face look longer. The fringe is cut dry at the brow with flat shears; long layers are point cut from the chin for movement at the sides. Flat brush on the fringe, round brush on the length. Trim the fringe every four weeks.

12. Over-60 Hair for Oblong Face Shape: Brow Fringe and Soft Layers

hair for oblong face shape

Fine to medium density and 1A to 2A texture suit my usual hair for oblong face shape over 60: a chin perimeter, soft layers, and a brow fringe. The perimeter is cut dry with point cut ends, layers point cut from the cheekbone, fringe cut at the brow and then point cut. Round brush plus smoothing cream to dry. Trim every six weeks and gloss every eight.

13. Pixie Cut With a Sideways Fringe

hair for oblong face shape

Fine to medium density and 1A to 2A texture suit a pixie with a side swept fringe on an oblong face, provided the top stays low and the fringe travels sideways. Sides and nape are cut scissor over comb on dry hair, three inches left on top, and the fringe runs from the part to the cheekbone. Flat-brush the fringe across; keep the crown flat. Trim every five weeks.

14. Lob With Layers and a Deep Side Part

hair for oblong face shape

Fine to medium density and 1A to 2B texture suit a layered lob with a side part at the collarbone, as long as I’ll take an oblong face without a fringe. The collarbone perimeter is cut dry with point cut ends, layers point cut from the cheekbone, part set on the heavier side. Round-brush, rolling the sides out. Trim every eight weeks.

15. Chin-Length Wavy Short Hair for Oblong Face Shape

hair for oblong face shape

Fine to medium density with 2A to 2C texture is who this suits: short hair for oblong face shape clients with wave, kept at the chin so the bend adds width beside the jaw. The chin perimeter is cut dry with point cut ends, interior left solid. Scrunch sea salt spray into damp hair, side part, air-dry. Trim every six weeks.

16. Curly Bob Cut to the Jaw

hair for oblong face shape

Medium to thick density with 3A to 3C texture is ideal for a curly bob at the jaw, which gives an oblong face the width of curl minus the length that stretches it. Each curl is cut dry at the jaw, then layers go in from the cheekbone so the curls stack to the sides. Rake curl cream through wet hair and diffuse low. Trim every eight weeks.

17. Bottleneck-Bang Chin Bob

hair for oblong face shape

On an oblong face with fine to medium density and 1B to 2B texture, bottleneck bangs narrow at the brow and spread at the cheekbone, covering the forehead and widening the face in the same stroke. The chin perimeter is cut dry with point cut ends; a triangle section becomes bangs, short at center and longer toward the cheekbone. Small round brush on the bangs. Trim every four weeks.

18. Face-Frame Layers on a Shoulder Cut

hair for oblong face shape

Fine to thick density with 1A to 2B texture suits face framing layers that start at the cheekbone and curve outward, adding width at the narrowest part of an oblong face. The shoulder perimeter is cut dry with point cut ends, and the face frame is point cut from cheekbone to collarbone. Round-brush the frame away from the face. Trim every eight weeks.

19. Chin-Length Cut With a Sweeping Side Fringe

hair for oblong face shape

On an oblong face with fine to medium density and 1A to 2A texture, a side swept fringe on chin length hair lowers the forehead and adds width in one go. The chin perimeter is cut dry with point cut ends, and the fringe runs from the part to the cheekbone with point cut ends too. Flat-brush the fringe across and turn the bob under. Trim every six weeks.

20. Soft-Ended Razor Cut Bob

hair for oblong face shape

Medium to thick density and 1B to 2B texture on an oblong face suit a razor cut bob, whose soft ends at the jaw make width look like texture instead of a hard shelf. The jaw perimeter is cut dry, the last two inches razored, plus razored face framing pieces from the cheekbone. Rough-dry with a light cream; let the ends fall. Trim every six weeks.

21. Jaw Bob Short Hair for Oblong Face Shape With Blunt Fringe

hair for oblong face shape

Fine to medium density and 1A to 1C texture suit the short hair for oblong face shape detail I reach for most: a blunt fringe covering the forehead in one line. A jaw bob is cut dry with point cut ends, and the fringe goes at the brow with flat shears. Flat brush for the fringe, round brush for the bob. Trim the fringe every four weeks.

22. Balayage Waves at the Shoulder

hair for oblong face shape

On an oblong face with fine to thick density and 1B to 2B texture, balayage on shoulder length waves keeps the brightest pieces at the cheekbone so the eye registers width. The shoulder perimeter is cut dry with point cut ends and a chin layer, then hand painted to a level nine from the cheekbone down. A one-inch iron and serum finish it. Refresh every twelve weeks.

23. Fringe-Front Wolf Cut

hair for oblong face shape

Medium to thick density and 1B to 2C texture on an oblong face suit a wolf cut with a fringe: short crown layers that fall sideways and a fringe across the forehead. The fringe is cut dry at the brow, the crown layers point cut short, the lengths razored past the shoulder. Rough-dry with texture spray, pushing the crown out instead of up. Trim every eight weeks.

24. Tucked-Side Chin Bob

hair for oblong face shape

Fine to medium density and 1A to 2A texture suit a chin length bob with one side tucked, leaving the other full so an oblong face widens on the heavy side. The chin perimeter is cut dry with point cut ends, and the tucked side is texturized a bit shorter. Round-brush the heavy side out, tuck the other, light spray to set. Trim every six weeks.

25. Shoulder-Length Soft Waves With a Fringe for Over 40

hair for oblong face shape

Fine to medium density and 1A to 2B texture suit soft waves with a fringe on shoulder length hair, giving an oblong face over 40 side width and a covered forehead. The shoulder perimeter is cut dry with point cut ends, the fringe cut at the brow and point cut, layers added from the chin. A one-and-a-quarter-inch iron, then brush out. Trim every eight weeks.

See also hair for round face shape double chin and hair for rectangle face shape.

Hair for an oblong face shape reads better with width at the cheek and less drop at the back, since more length only stretches the face further. A curtain fringe cut to the brow is what shortens the look.

Save this article

Enter your email and we'll send it straight to your inbox.

No spam. Unsubscribe anytime.

Scroll to Top